1999 Polaris SLH, SLTH, SLX, SLTX, PRO785 Factory Service Manual, Page 62Get this manual
MAINTENANCEfTUNE UP HUllDeck NOTE: On SLT Models, do not close compartment door with hinge nuts, latch striker plate, or latch post looseThe door may be extremely difficult to re-openHold plate in position and tighten boltsalignmentLoosen lock nut on latch post
Re-check
Turn post clockwise to provide more seal and latch pressure or counterclockwise to reduce pressure (if door is too tight or new seal installed)Tighten lock nut on postCheck operation and repeat procedure if necessary
Compartment Door AlignmentSL Models
1Open storage compartment door and make sure rubber guide bumpers on corners of steering pod and along edges of door are in place and in good condition 2Visually check alignment of door along both edges and at top corner of podThe gap should be equal on both sides3If adjustment is necessary, mark location of hinges with pencil for referenceRemove storage bucket and loosen two main hinge nuts (inside under top deck) just enough to allow adjustment of doorShift door to side of smaller gap until equal on both sidesHold door in position and tighten nutsRe-adjust if necessary until door is aligned along both edges When properly aligned, check to make sure it latches securely and tightly