1999 Polaris PWC Genesis, Ficht, X-45 Service Manual, Page 293Get this manual
DIAGNOSTIC SOFTWARE Error Messages If the program doesn't start, an error message will appear explaining the problemIf the program doesn't start, AND doesn't display an error message, the problem is most likely insufficient computer memoryThis error message indicates that the communication port will not openThis message is usually caused by the following problems
ERROR OPENING PORT NUMBERPRESS ANY KEY TO TRY AGAIN
The selected corn port does not exist on your computerMake sure you selected the correct com portMost computers have at least two com portsThe ports are normally labeled com and com 2Consult the documentation for your computer to determine the name of the port you have plugged the diagnostic communication cable intoMake sure the diagnostic program is set up to use the same portSee the section titled Changing Com Port in this bookletSome computers have the ability to enable and disable the com portsConsult the documentation that came with your computerMake sure the corn port is enabled