1999 Polaris PWC Genesis, Ficht, X-45 Service Manual, Page 282Get this manual
FICHT FUEL INJECTION Action StepsFuel System Step 6: Voltage Supply TestsBattery must be of adequate capacity, fully charged with clean, tight connectionsARemove a-pin connector from rear of EMM and connect F1CHT EMM Service Power Connector PN 2872456BInstall tether cord to stop switch
CVerity fused B+(battery positive) al RedPurple wire, terminals and at the PCM (Power Control Module) pin connector (see Chapter 9, page 22)There should be more than 9.5 volts while cranking, or more than 13 volts while runningResults:
OKverify 45 volt systemGo to Step C
No voltagetest stop circuitSee Step of Action StepsIgnition System in this section
Low voltage: Verify battery capacity, condition, and connectionsTest current draw of starter motor
OVerify 45 volt system by checking voltage at terminals and at the PCMCheck for any of the following:
Remove 8-pin connector from rear of EMM and connect FICHT EMM Service Power Connector (PN 2872456)Tether cord connected to stop switchengine not runningCrankingapproximately 20 voltsEngine runningmore than 24 volts and steady at idleMore than 40 volts and steady above 3500 RPMResults: As specifiedcheck supply voltage at injectorGo to Step OAny less than specifiedtest charging system