1999 Polaris PWC Genesis, Ficht, X-45 Service Manual, Page 214Get this manual
HULUDECK, STEERING AND CONTROLS Cable Adjustments Alternate Method 01 Measuring Nozzle
Following is an alternate method for checking nozzle centering
Rear View Of Pump Nozzle
1Perform steps and on page 6.15 to center
handlebars2Measure distance from rear-most edge of steering nozzle (or trim nozzle) to stationary pump nozzle
(extension housing) with 6" steel rule or vernier caliperMeasure at the same point on both left and fight sides along horizontal center lineThe distance should be equalSee Ill1Measure on horizontal center line from rear of steering or trim nozzle to stationary nozzleDistance should be equalIll1
Adjustment Procedure
1Minor adjustments can be made using the steering cable rod end(s)Loosen jam nut on rod end(s)Remove end from top of steering nozzleTurn rod end in or out to adjustReinstall rod end, apply Small adjustments