1999 Polaris PWC Genesis, Ficht, X-45 Service Manual, Page 87Get this manual
FUEL SYSTEMCARBURETION FuellWater Separator IMPORTANT: Prior to performing any adjustments to carburetors check the following:
Verify that no water is present in the fuel system, Check
the water trap for presence of water
Check for proper choke operation,
Verify all fuel and vent lines are routed and secured properly Check the reed valves for damage Check fuel pump diaphragms for damage
Verify an seal and gaskets are in good condition (no air leaks present) Check engine compression (see engine section)
Verify proper fuel flow (i.efuel flow through shut off valve)
Synchronize carburetors; inspect throttle plates (butter
fly) for damage
FuellWater SeparatorX-45 and Genesis
The water trap should be checked daily andor whenever refueling1"-2" (2 .5-5 cm) of water depth in water trap can cause engine to run poorlyIf water trap fills quickly, excessive water may be present in fuel tankThe water trap includes filter to improve water separation, and colored float to indicate water levelEmpty trap if float appears to be off the bottom NOTE: The maximum travel of the float is to the base of the filter, or approximately one half the depth of the bowlVisually inspect the bowl for water collected at the bottom of the bowlSee illustrationIf water is present it will appear as clear liquid at the bottom of the bowlTurn off fuel valveWrap shop towel around the bowl and remove bowl by turning counterclockwise Take care not to spill fuel while removingWipe up spills immediately with shop cloth Dispose of fuel properly and follow all gasoline hand ling precautions found on page 3.37Reinstall separator bowl taking care that the O-ring is undamaged and in the proper placeHand tighten securelyCheck carefu lly for fuel leaks around bowl