2008 Honda Aquatrax ARX1500T3/T3D factory service manual, Page 426Get this manual
SPEED SENSOR REMOVAL INSTALLATION Remove the reverse bucket (page 15-15)Disconnect the speed sensor 2P (White) connector
Benot to Loosen the speed sensor wire holder nut, using the damage the serisor special toolconnector when retnoving tthrough TOOL: 07LAA-PT50101 the holder nut sensor wrench (not available in hole u.s.A Do not dsassemble Use commerciall the speed senser
1 o2SENSOR WRENCH
available equivalent
Remove the four screws and speed sensorInstall the speed sensor and tighten the four screwsInsert the speed sensor 2P (White) connector through the wire holder nut holelnstall the wire holder nut into the hole and tighten it, using the special toolConnect the speed sensor 2P (White) connectorInstall the jet pump (page 14-14)