2008 Honda Aquatrax ARX1500T3/T3D factory service manual, Page 373Get this manual
STEERINGIREVERSE SYSTEM
THROTTLE LEVER
REMOVALIINSTALLATION
Remove the following:
- handlebar cover (page 3-12)seats (page 3-5)
Slide the sleeve back to expose the adjusterLoosen the lock nuts and turn the adjuster loosen the throttle cable
ADJUSTER
Loosen the cable joint nut and remove the throttle cable from the throttle lever and lever bracketTake care not to Remove the pivot bolt and nutbend the return Release the throttle lever off the lever bracket while sprng sliding its upper pivot forward carefully and remove
JOINT NUT
PIVOT BOLT
the return springApply water-displacement corrosion-proof lubricant (without Teflon or molybdenum additives, such as CRC 6-56 or an equivalent) to the throttle cable end and connect the cable to the throttle leverInstall the joint nut of the throttle cable into the lever bracketSet the return spring onto the lever bracket by inserting the long end into the setting holeCarefully align the short end of the spring with the setting hole in the lever, then install the throttle lever onto the bracketApply locking agent to the threads of the lever pivot bolt, and install the pivot bolt and nutMake sure the throttle lever operates smoothly without binding and tighten the pivot boltTORQUE: 4.0 N-m (0.41 kgfm, 3.0 Ibf-ft)