2008 Honda Aquatrax ARX1500T3/T3D factory service manual, Page 371Get this manual
STEERINGREVERSE SYSTEM Make sure to set the switch lever onto the guide rail of the cable arm properlyApply locking agent to the steering cable arm holder nut threads, and install the cable arm holder, washers and nutsTighten the nuts alternately
TORQUE: 10 N.m (1.0 kgf-m, Ibf-ft)
Apply water resistant molybdenum disulfide grease to the steering cable joint pivotConnect the steering cable to the joint bolt and install the washer and joint pivot lock nutHold the bolt and tighten the joint pivot lock nut
TORQUE: 10 N-m (1.0 kgf-m, Ibf-ft)
Apply water-displacement corrosion-proof lubricant (without Teflon or molybdenum additives, such as CRC 6-56 or an equivalent) to the steering cable inner and water resistant grease to the limit switch lever sliding area (guide rail)Make sure the steering shaft moves smoothly, without play or bindingPlace the handlebar onto the holders of the steering shaft while inserting the handlebar switch wire into the steering shaft and align the punch mark on the handlebar with the left holderInstall the handlebar holders and bolts with the punch marks on the holders facing upTighten the upper bolts first, then tighten the lower bolts