2008 Honda Aquatrax ARX1500T3/T3D factory service manual, Page 358Get this manual
PROPULSION SYSTEM Remove the following:
- four bolts and washers thrust plate (being careful not to bend steering and reverse cables)bilge hose joint and O-ringwater hose joint and O-ringintake lip
INSTALLATION
Strip off any old sealant thoroughly from the thrust plate when reusing itApply 70 (2.5 oz) of silicone sealant to the mating surface of the thrust plate as shownInstall new O-rings into the hose joint groovesInstall the water hose and bilge hose joints onto the thrust plateInstall the thrust plate through the steering and reverse cables, being careful not to damage themInstall the washers onto the thrust plate bolts, and apply locking agent to the bolt threads and apply 0.51.0 (0.020.04 oz) of LORD 7542 or equivalent (1:l mix of two urethane based adhesives) to the seating surfaces of the washersInstall the bolts and tighten them in crisscross pattern in several steps