2008 Honda Aquatrax ARX1500T3/T3D factory service manual, Page 354Get this manual
PROPULSION SYSTEM Tighten the bearing housing mounting nutsTORQUE: 22(2.2 kgf,m, 16 Ibf-ft) Remove the special toolsNUTS
DRIVE SHAFT INSTALLATION
Insert the drive shaft into the bearing housing slowly, being careful not to damage the seals in the bearing housingInstall the shaft collar onto the drive shaftApply water resistant molybdenum disulfide grease the splines of the driven coupler and install it onto the drive shaftApply engine oil to the threads of the coupler bolt and install it with the washerHold the rear hex portion of the driven coupler using 1mm wrench
DRIVEN COUPLER
Tighten the coupler bolt to the specified torque by holding the coupler bossU.S.ATOOL: Axle nut holder wrench, 41 BOLT AND WASHER