2008 Honda Aquatrax ARX1500T3/T3D factory service manual, Page 353Get this manual
PROPULSION SYSTEM BEARING HOUSING INSTALLATION Install the housing boot band over the boot band base by aligning the band screw with groove of boot band baseThe trumpet shape Set the boot band assembly over the housing boot'lde
Of boot band Install the bearing housing over the drive shaft base shOu'd be guide and onto the stud boltsfaced to bearing Tighten the boot band screw to the specified torquehousna -
HOSE BANDS
TORQUE: N-m (0.10 kgf-m, 0.7 Ibf-ft)
Tighten the nuts Install the three nuts with the washers (but do not when aligning the tighten them yet)bearing housing position
Connect the grease fitting and breather hoses, and secure them with hose bands
BOOT BAND
BAND BASE
NUTS AND WASHERS Align the bearing housing position using the special tools as follows