2008 Honda Aquatrax ARX1500T3/T3D factory service manual, Page 278Get this manual
CYLINDER HEADIVALVE
CAM CHAIN TENSIONER LIFTER
REMOVAL
Remove the cylinder head cover (page 10-7)Remove the tensioner lifter sealing bolt and sealing washer located on the right rear side of the upper crankcase, being careful not to drop them
Turn the cam chain tensioner lifter shaft clockwise fully and secure it with the special tool to loosen the tensioner lifterTOOL: Tensioner stopper
070MG-0010100 or 07AMG-001A100 (U.S.Aonly)
Remove the bolts, cam chain tensioner lifter and gasket
INSPECTION
Check the lifter operation as followsThe tensioner shaft should not go into the body when it is pushedWhen it is turned clockwise with the stopper tool, the tensioner shaft should be pulled into the bodyThe shaft spring out of the body as soon as the stopper tool is releasedTOOL: Tensioner stopper