2008 Honda Aquatrax ARX1500T3/T3D factory service manual, Page 275Get this manual
CYLINDER HEADIVALVE Install the head cover onto the cylinder head, aligning the semi-circular areas of the gasket and cylinder head carefullyThe "UP" mark of the washer is facing the bolt head
WASHER ("UP" MARK)
Install the cover bolts with the special washers by aligning them with the bolt hole in the cylinder head
First tighten the two bolts, indicated by the triangular marks, to the specified torque
Tighten the four cover bolts in several steps
TORQUE: 10 N-m (1.0 kgf.m, Ibf-ft)
Connect the crankcase breather hoseInstall the engine dipstickInstall the following: