2008 Honda Aquatrax ARX1500T3/T3D factory service manual, Page 243Get this manual
ENGINE REMOVALIINSTALLATION ENGINE-TO-JET PUMP ALIGNMENT Loosen all the engine mounting boltsLift the engine slightly and install the engine mounting shims into the clearances between the rubber mounts and engine supports in their original locationsMOUNTING BOLT
SHIM Check the engine-to-jet pump alignment using the following special toolsDOWEL SETTING PLATE
TOOLS: Alignment tool setstopper collarstopper collar (not used)setting platecenter support and shaftcoupler attachment
070MJ-HWIA101 07AMJ-HW5A130 070MJ-HWlA140 070MJ-HWlA130 070MJ-HWlA120 070MJ-HWlA110
Install the two dowel pins into the thrust plateInstall the setting plate onto the thrust plate with the jet pump mounting bolts, adding the special washers from the Stopper collar set on the two lower mounting bolts, and the center support into the setting plate with the dowel pins and four socket bolts (including special tool) as shownTighten all the bolts securelyLoosen the mounting nuts of the bearing housing before installing the alignment shaft