2008 Honda Aquatrax ARX1500T3/T3D factory service manual, Page 196Get this manual

2008 Honda Aquatrax ARX1500T3/T3D factory service manual, Page 196

FUEL SYSTEM (Programmed Fuel Injection) Connect the voltmeter to the wire harness side connector terminalsConnection: Blacklbrown (+)

FUEL PUMP 5P (Gray) CONNECTOR (Wire sidelfemale terminal)

Insert the safety lanyard lock clip in engine stop switch and measure the voltageThere should be battery voltage for few secondsIf there is battery voltage, replace the fuel pump- open circuit in the Blacldbrown wire between the

If there is no voltage, inspect the following:

fuel pump and fuel pump relayopen circuit in the Green wire between the fuel pump and fuel ground terminalloose or poor contact of the related connectorfuel pump relay and its circuits (page 8-78)

BlacWbrown

REMOVAL
Remove the fuel tank (page 8-61)Loosen the fuel pump lock nut, using the special tool
TOOL: Fuel sender wrench