2008 Honda Aquatrax ARX1500T3/T3D factory service manual, Page 158Get this manual
FUEL SYSTEM (Programmed Fuel Injection) DTC 1-2 (MAP SENSOR HIGH VOLTAGE)
Before starting the troubleshooting, check the MAP sensor connector for loose contacts or corroded terminals, and recheck the DTC1MAP Sensor System Inspection Insert the safety lanyard lock clip in engine stop switchCheck the MAP sensor with the HDS,
Is about Vindicated?
- GOTOSTEP2- Intermittent failureLoose or poorly connected ECM connector
2MAP Sensor Output Voltage Inspection
Pull the safety lanyard lock clip off of the engine stop switchDisconnect the MAP sensor 3P (Black) connectorInsert the safety lanyard lock clip in engine stop switchMeasure the voltage between the wire harness side connector terminalsConnection: Blue blackGreenlyellow
MAP SENSOR 3P (Black) CONNECTOR (Wire sidelfemale terminal)
Is the voltage within 4.755.25 V?