2008 Honda Aquatrax ARX1500T3/T3D factory service manual, Page 105Get this manual
FLUSHING AND STORAGE- 8Remove the drain plugs, and clean the outside of the engine and bilgeRinse and drain thoroughlyUse shop towel to dry the water craft and then spray water-displacement corrosion-proof lubricant (without Teflon or molybdenum additives, such as CRC 6-56 or an equivalent)Also rinse and dry the turbocharger, and spray it with the same lubricant (page 4-18)
Never clean the fiberglass and plastic parts with strong detergent or degreasing agentThese products will damage the gel-coat finish9Wash the exterior of the watercraft and rinse thoroughly
Apply fiberglass marine wax to the hull and deck10.Lubricate the following control cables:
- throttle lever (page 4-4)handlebar and steering nozzle (page 4-24)
- reverse lever and reverse bucket (page 4-21)
11.Store the watercraft in an unheated area, with low humidity, away from sunlight, and with minimum of daily temperature variation
REMOVAL FROM STORAGE
Before starting the engine, remove the seats and front storage box to ventilate the engine compartment1Remove the following: