2008 Honda Aquatrax ARX1500T3/T3D factory service manual, Page 104Get this manual
FLUSHING AND STORAGE
STORAGE
PREPARATION FOR STORAGE
1Flush the cooling system (page 5-3)
2Remove the bilge drain plugs to drain any waterRaise the bow (front) of the watercraft about foot allow complete draining
3To prevent rusting the inlet valves, proceed as follows after confirming the engine is cool- Remove the seats (page 3-5)Remove the maintenance port cap from the throttle body
MAINTENANCE PORT
Do not raise the engine speed above the idling speed (1,200 100 rpm) while spraying the lubricant
- Start the engine at idle speed (without pulling
the throttle lever) and spray water-displacement corrosion-proof lubricant (without Teflon or molybdenum additives, such as CRC 6-56 or an equivalent) into the maintenance port for 20 secondsThen immediately stop the enginetightened securelyTo prevent the cylinders from rusting, perform the following: Remove all the spark plugs (page 4-6)Disconnect all the fuel injector connectorsPour tablespoon (1520 cc) of clean engine oil into each cylinder through the spark plug holes and cover the spark plug holes with shop towelTo stop the warning beeper, press and hold any of the SET, MODE, ID SET and ID No buttons for seconds