2004-2007 Honda Aquatrax ARX1200N3/T3/T3D Factory Service Manual, Page 485Get this manual
METERSWITCHES 4GPS Receiver Replacement Replace the GPS receiver with known good oneFit the safety lanyard clip to the base of the engine stop switch, wait for minutes and recheck the GPS indicatorIs the GPS indicator still blinking? YES NO Faulty combination meter Faulty original GPS receiverINDICATOR
GPS START-UP TIME IS TOO LONG 1Recheck with the GPS System Reset Disconnect the battery negative () cable and reconnect it (page 16-5)Fit the safety lanyard clip to the base of the engine stop switch, wait until the GPS system starts-up and pull the safety lanyard clip offAfter the combination meter is off (approximately 10 seconds later), re-fit the safety lanyardDoes the GPS start-up within 30 seconds? YES NO No problem (Temporary failure) GO TO STEP 2
2GPS Receiver Back-up Voltage Inspection Remove the post cover without disconnecting the meter connectors (page 3-7)Pull the safety lanyard clip off of the engine stop switchRemove the GPS receiver 6P connector from the stay and disconnect itMeasure the voltage between the meter side connector terminal and groundConnection: Blackblue (+) Ground () Is there battery voltage? YES NO Faulty GPS receiver Open or short circuit in the Black blue wire Inspect the back-up voltage line of the combination meter (page 19-4)METER SIDE 6P CONNECTOR (Viewed from the terminal side)