2004-2007 Honda Aquatrax ARX1200N3/T3/T3D Factory Service Manual, Page 478Get this manual
METERSWITCHES LIMIT MODE INDICATOR Fit the safety lanyard clip to the base of the engine stop switchMeasure the voltage between the Blueyellow wire terminal (+) of the ECM 26P gray connector and ground ()There should be approximately VIf there is no voltage, check an open circuit in the Blueyellow wireECM 26P GRAY CONNECTOR (viewed from the terminal side)
Blueyellow
Ground the Blueyellow wire terminal with jumper wireThe "LIMIT MODE" indicator should come onIf the "LIMIT MODE" indicator does not come on, replace the combination meter
ARX1200T3N3 shown: "LIMIT MODE" INDICATOR
OFF-THROTTLE STEERING INDICATOR Fit the safety lanyard clip to the base of the engine stop switchMeasure the voltage between the Whiteblack wire terminal (+) of the ECM 26P gray connector and ground ()There should be approximately VIf there is no voltage, check an open circuit in the Whiteblack wireECM 26P GRAY CONNECTOR (viewed from the terminal side)