2004-2007 Honda Aquatrax ARX1200N3/T3/T3D Factory Service Manual, Page 460Get this manual
ELECTRIC STARTER POWER INPUT LINE Disconnect the starter relay switch 2P connectorFit the safety lanyard clip to the base of the engine stop switchMeasure the voltage between the wire harness side connector terminal (+) and ground ()CONNECTION: Yellowred (+) Green () There should be battery voltage when the starter switch is depressedGreen Yellowred WIRE HARNESS SIDE CONNECTOR (Viewed from terminal side)
FUNCTION Remove the safety lanyard clip from the engine stop switchDisconnect the battery and starter motor cables from the starter relay switchConnect an ohmmeter to the starter relay switch cable terminalsConnect fully charged 12-V battery to the starter relay switch connector terminalsCONNECTION: Yellowred (+) Green () There should be continuity while the 12-V battery is connected to the starter relay switch connector terminals and there should be no continuity when the battery is disconnectedAfter inspection, connect the battery cable, starter motor cable and starter relay switch connectorInstall the starter relay switch box cover, connector stay and tighten the six screwsTORQUE: 1.0 Nm (0.1 kgfm, 0.7 lbfft) Install the passenger grab rail (page 3-5)