2004-2007 Honda Aquatrax ARX1200N3/T3/T3D Factory Service Manual, Page 425Get this manual
STEERINGREVERSE SYSTEM BUCKET ARM REMOVAL INSTALLATION Remove the following: reverse bucket (page 15-13) bucket catch bolts and washers bucket catches reverse cable (sliding cable joint outer sleeve forward and disconnect it) pivot bolt, washer and collar reverse bucket arm pivot bushings Apply water resistant molybdenum disulfide grease to the bucket arm pivot and bushingsInstall the pivot bushingsApply locking agent to the pivot bolt threadsInstall the bucket arm with the pivot bolt, washer and collar, and tighten itTORQUE: 22 Nm (2.2 kgfm, 16 lbfft) Apply water resistant molybdenum disulfide grease to the reverse cable joint pivotConnect the reverse cable to the bucket armInstall each bucket catch into the grooves and onto the pins on the bucket armApply locking agent to the threads of the bucket catch boltsInstall each catch bolt with the washer and tighten themTORQUE: 9.8 Nm (1.0 kgfm, lbfft) Pull the reverse cable fully and apply water-displacement corrosion-proof lubricant (without Teflon or molybdenum additives, such as CRC 6-56 or an equivalent) to the reverse cable innerInstall the reverse bucket (page 15-15)BUSHINGS