2004-2007 Honda Aquatrax ARX1200N3/T3/T3D Factory Service Manual, Page 421Get this manual
STEERINGREVERSE SYSTEM Make sure to set the switch lever onto the guide rail of the cable arm properlyApply locking agent to the arm nut threads, and install the cable arm holder, washers and nutsTighten the nuts alternatelyTORQUE: 6.9 Nm (0.7 kgfm, 5.1 lbfft) Apply water resistant molybdenum disulfide grease to the steering cable joint pivotConnect the steering cable to the joint bolt and install the washer and joint nutTighten the joint bolt, then the joint nutTORQUE: 9.8 Nm (1.0 kgfm, lbfft) Apply water-displacement corrosion-proof lubricant (without Teflon or molybdenum additives, such as CRC 6-56 or an equivalent) to the steering cable inner and water resistant grease to the limit switch lever sliding area (guide rail)Make sure the steering shaft moves smoothly, without play or bindingPlace the handlebar onto the holders of the steering shaft while inserting the handlebar switch wire into the steering shaft and align the punch mark on the handlebar with the left holderInstall the handlebar holders and bolts with the punch marks on the holders facing upTighten the upper bolts first, then tighten the lower boltsTORQUE: 22 Nm (2.2 kgfm, 16 lbfft) Insert the wire of the warning buzzer into the steering shaftHANDLEBAR PUNCH MARK PUNCH MARK HOLDER BUZZER JOINT NUT WASHER CABLE ARM NUTS AND WASHERS ARM HOLDER JOINT BOLT