2004-2007 Honda Aquatrax ARX1200N3/T3/T3D Factory Service Manual, Page 409Get this manual
PROPULSION SYSTEM INSTALLATION Install the intake lip after installing the thrust plate
Strip off any old sealant thoroughly from the thrust plate when reusing itApply 70 (2.5 oz) of silicone sealant to the mating surface of the thrust plate as shown10 mm (0.4 in)
70 (2.5 oz) Install new O-rings into the hose joint groovesInstall the water hose and bilge hose joints onto the hullInstall the thrust plate through the steering and reverse cables, being careful not to damage themInstall the washers onto the thrust plate bolts, and apply locking agent to the bolt threads and LORD 7542 or equivalent (1:1 mix of two urethane based adhesives) to the seating surfaces of the washersInstall the bolts and tighten them in crisscross pattern in several stepsTORQUE: 39 Nm (4.0 kgfm, 29 lbfft) Align the engine-to-jet pump (page 9-11)5 mm (0.2 in) STEERING CABLE BILGE HOSE THRUST PLATE