2004-2007 Honda Aquatrax ARX1200N3/T3/T3D Factory Service Manual, Page 404Get this manual
PROPULSION SYSTEM Press the outside bearing with the marking facing up until the depth from the bearing holder end is 9.8 10.2 mm (0.39 0.40 in)TOOLS: Driver Attachment, 42 47 mm Pilot, 25 mm 07749-0010000 07746-0010300 07746-0040600 DRIVER 9.8 10.2 mm (0.39 0.40 in)
ATTACHMENT
Install new water seal with the groove side facing the bearing until it is fully seatedApply water resistant grease #2 to the seal lipsInstall the snap ring into the housing groove with the chamfered (rolled) edge facing the water seal properlyWipe off any excess grease from the bearing and stopper seal
SNAP RING
WATER SEAL
BEARING HOUSING INSTALLATION
Set the clamp over the housing boot in the direction as shown and install the bearing housing over the drive shaft guide and onto the stud boltsTighten the nuts when aligning the bearing housing position