2004-2007 Honda Aquatrax ARX1200N3/T3/T3D Factory Service Manual, Page 403Get this manual
PROPULSION SYSTEM Remove the water seals from the bearing holder using the special toolsTOOLS: Bearing remover, 25 mm 07936-ZV10100 07936-ZV1A100 (U.S.Aonly) 07936-3710100 07741-0010201 or 07936-3710200 or 07936-371020A (U.S.Aonly) WATER SEAL
Remover handle Remover weight
Clean the inner surface of the bearing holder thoroughlyApply water resistant grease #2 to the lips of new water sealsHold the housing bottom using 35 mm (1.4 in) O.Dcollar
DRIVER ATTACHMENT
Install the water seal (bottom) with the flat surface facing up until it is fully seatedTOOLS: Driver Attachment, 32 35 mm Pilot, 25 mm 07749-0010000 07746-0010100 07746-0040600 WATER SEALS PILOT