2004-2007 Honda Aquatrax ARX1200N3/T3/T3D Factory Service Manual, Page 401Get this manual
PROPULSION SYSTEM Hold the rear hex portion of the driven coupler using 41mm wrench
Hold the driven coupler and loosen the coupler boltRemove the following: bolt and washer driven coupler shaft collar drive shaft
DRIVEN COUPLER BOLT AND WASHER
DRIVE SHAFT
BEARING HOUSING REMOVAL
When installing, the special tools is required to align the housing position (page 14-29)
Remove the following from the bearing housing: hose band and grease fitting hose hose band and breather hose three nuts and washers Loosen the boot clamp and remove the bearing housing