2004-2007 Honda Aquatrax ARX1200N3/T3/T3D Factory Service Manual, Page 394Get this manual

PROPULSION SYSTEM The bearing mark should face away from the shaft threads
Press new inside bearing (6205) with the marking facing up until it is fully seatedTOOLS: Driver Attachment, 42 47 mm Pilot, 25 mm 07749-0010000 07746-0010300 07746-0040600

ATTACHMENT

Pack the bearing cavity with water resistant grease #0
Hold the inner race with the marking facing up
Press the impeller shaft into new outside bearing (6305) squarely until it is fully seatedInstall the snap rings so the chamfered (rolled) edge faces each bearingPack the bearing cavity with water resistant grease #0
IMPELLER SHAFT

• ATV
• Jet Ski
• Outboard Motors
• Personal Watercraft
• Snowmobiles
• Stern Drives