2004-2007 Honda Aquatrax ARX1200N3/T3/T3D Factory Service Manual, Page 392Get this manual
PROPULSION SYSTEM Apply molybdenum disulfide grease to the threads of the impeller shaftInstall the impeller by turning the impeller shaft, being careful not to interfere the impeller with the jet stator wallHold the impeller shaft of the jet pump assembly in viseTighten the impeller using commercially available impeller wrenchTOOL: Impeller wrench Solas WR001 or equivalent WRENCH IMPELLER (Impeller shaft)
TORQUE: 127 Nm (13.0 kgfm, 94 lbfft)
If the impeller was replaced, coat new rubber stopper with molybdenum disulfide grease and install it into the impeller securely
Measure the distance between the impeller end and rubber stopperIf the distance is smaller than 49 mm (1.9 in), it indicates that air and grease are sealed between the rubber stopper and impeller shaftPress the rubber stopper to extrude them, using 10 12 mm O.DshaftMake sure that the impeller rotates smoothly without binding