2004-2007 Honda Aquatrax ARX1200N3/T3/T3D Factory Service Manual, Page 290Get this manual
ENGINE REMOVALINSTALLATION
ENGINE INSTALLATION
Whenever removing the engine from the watercraft, engine-to-jet pump alignment must be performed at installation Route the wires, cables and hoses properly page 1-31 or 1-52)Remove the drive shaft (page 14-26)Place the engine into the body, being careful not to damage the deckCarefully align the mounting bolt holes in the engine and rubber mountsTighten the mounting bolts to the specified torque after adjusting the engine-to-jet pump alignment
BOLT AND WASHER
Adjust the height of the hoist and lower the engine and set it onto the rubber mounts (but do not remove the sling and hoist yet)Apply engine oil to the threads and seating surfaces of the mounting boltsInstall the four mounting bolts with the washers and temporarily tighten them