2004-2007 Honda Aquatrax ARX1200N3/T3/T3D Factory Service Manual, Page 235Get this manual
FUEL SYSTEM (Programmed Fuel Injection) Connect the fuel return hose to the fuel hose joint on the oil tankRemove the jumper wire and test harness, and connect the ECM 22P gray connectorFit the safety lanyard clip to the base of the engine stop switch and check that there is no fuel leakageInstall the seats (page 3-4)FUEL RETURN HOSE
FUEL HOSE JOINT
FUEL PUMP
INSPECTION
Remove the storage box (page 3-8)Fit the safety lanyard clip to the base of the engine stop switch and confirm that the fuel pump operates for few secondsIf the fuel pump does not operate, inspect as follows: Remove the safety lanyard clip from the engine stop switchDisconnect the fuel pump 5P gray connectorFUEL PUMP 5P GRAY CONNECTOR
Connect the voltmeter to the wire harness side connector terminalsConnection: Blackorange (+) Green () Fit the safety lanyard clip to the base of the engine stop switch and measure the voltageThere should be battery voltage for few secondsIf there is battery voltage, replace the fuel pumpIf there is no voltage, inspect the following: open circuit in the Blackorange wire between the fuel pump and fuel pump relay open circuit in the Green wire between the fuel pump and fuel ground terminal loose or poor contact of the related connector fuel pump relay and its circuits (page 8-106)