2004-2007 Honda Aquatrax ARX1200N3/T3/T3D Factory Service Manual, Page 148Get this manual
LUBRICATION SYSTEM Install the oil pump shaft and drive pinMeasure the rotor tip clearanceSERVICE LIMIT: 0.20 mm (0.008 in)
ASSEMBLY
When the oil pump drive joint is removed from the oil pump shaft, install as follows: Apply locking agent to the driven joint bolt threadsInstall the driven joint onto the oil pump shaft and tighten the boltTORQUE: 12 Nm (1.2 kgfm, lbfft) Apply light coat of clean engine oil to all partsInstall the following: oil pump shaft drive pin inner rotor while aligning its grooves with the drive pin outer rotor with the punch mark facing out two dowel pins oil pump spacer bolt BOLT PUMP SPACER