2004-2007 Honda Aquatrax ARX1200N3/T3/T3D Factory Service Manual, Page 126Get this manual
MAINTENANCE INSPECTION AND ADJUSTMENT Operate the reverse lever and check the movement of the reverse bucketIf the reverse bucket moves tightly or binds, inspect around the reverse bucket linkage (page 15-13)Pull the reverse lever up to set the reverse bucket downCheck to make sure the upper bucket catch (spring) should catch the guide collar of the bucket as shownAdjust the reverse bucket position as followsLower the reverse lever to move the reverse bucket upLoosen the cable joint lock nut and disconnect the reverse cable from the bucket arm by sliding the outer sleeve of the cable jointThe cable joint must be screwed in at least 13 mm (0.5 in)
BUCKET CATCH
GUIDE COLLAR
BUCKET ARM
Turn the cable joint as required (turn in; the clearance between reverse arm and guide collar is decreased) and connect the reverse cableAfter adjustment, tighten the lock nutTORQUE: 3.9 Nm (0.4 kgfm, 2.9 lbfft) Operate the reverse lever and recheck the bucket position