2004-2007 Honda Aquatrax ARX1200N3/T3/T3D Factory Service Manual, Page 103Get this manual
HULLHOODBODY PANELS
COUPLER COVER
ARX1200T3T3D:
Remove the rear tray (page 3-5)COVER B: Remove the two trim clips (release by pushing the center pin)Release the groove from the tab and rotate the coupler cover counterclockwise to remove itCOVER A: Remove the passenger grab rail (page 3-5)Remove the coupler cover bolt and washerRelease the grommet in the coupler cover from the crankcase and remove it while pulling the water hose asideAlign the hose groove on the cover with the water hose properly
HOSE TAB
GROMMET COVER GROOVE
BOLT AND WASHER BEARING HOUSING
Install the coupler covers in the reverse order of removalTORQUE: Coupler cover bolt: 9.8 Nm (1.0 kgfm, lbfft) Before installing the trim clip, raise the center pin by pushing the pin tip backInstall each trim clip and lock it by pushing the center pin flush