2004-2007 Honda Aquatrax ARX1200N3/T3/T3D Factory Service Manual, Page 96Get this manual
HULLHOODBODY PANELS
POST COVER
Remove the following: side covers (page 3-6) steering shaft (page 15-6) Disconnect the meter 10P (green) and 8P (gray) connectorsRelease the boot band and remove the meter wire boot off the deckDisconnect the reverse cable by removing the E-clip from the cable jointBe careful not to drop the cover nuts into the hull
Remove the following fasteners and the post cover: two tapping screws (open glove box lid) nine nuts (reverse side of deck) nine bolts and washers (post cover side) Refer to page 15-12 for reverse lever removal and installationInstallation is in the reverse order of removalTORQUE: Bolt: 9.8 Nm (1.0 kgfm, lbfft) Apply water resistant molybdenum disulfide grease to the cable joint pivotFor reverse lever and cable lubrication, see page 4-20POST COVER SCREWS