Yamaha F100B F100C Outboards Factory Service Manual, Page 277Get this manual
Power trim and tilt unit (F100C) Removing the power trim and tilt unit
1Fully tilt the outboard motor up, and then support it with the tilt stop lever 1NOTE: To remove the power trim and tilt unit, lower the tilt ram slightly
Installing the power trim and tilt unit
1Fully tilt the outboard motor up, and then support it with the tilt stop lever 1
S60C7750
WARNING
After tilting up the outboard motor, be sure to support it with the tilt stop leverOtherwise, the outboard motor could suddenly lower if the power trim and tilt unit should lose fluid pressureNOTE: If the power trim and tilt does not operate, loosen the manual valve and tilt the outboard motor up manually2Loosen the plastic ties 2, and then pull out the PTT motor lead 33Remove the bolt and disconnect the ground lead 54Remove the circlips 6, then shafts and 85Remove the power trim and tilt unit 9S60C7975