2009 Yamaha F40 Outboard Service Manual, Page 367Get this manual
Index Removing the oil pressure switch .7-47 Removing the oil seal housing, drive shaft, and shift rod .8-13 Removing the power unit 7-7 Removing the propeller shaft housing assembly.8-7 Removing the PTT motor9-47 Removing the PTT unit .9-43 Removing the starter motor .5-34, 7-29 Removing the stator assembly7-14 Removing the steering arm.9-34 Removing the thermo sensor7-47 Removing the throttle body .6-17 Removing the throttle link .6-21 Removing the timing belt and sprocket.7-15 Removing the upper case .9-22 Removing the vapor separator6-25 Removing the water pump 8-5 Removing the wiring harness7-22 Replacing the oil filter10-10 Replacing the timing belt.10-14 Replacing the valve guide.7-38 Reverse gear shim (T2) selection chart 8-39 Rigging grommet description 3-10 Rigging recommendations 3-21 Rotating part .0-1 Tightening torque 0-3 Tiller handle (tiller handle model) 5-10 Tiller handle model 1-14 Tilt down operation 2-19 Tilt up operation 2-18 Top view 5-7 Trouble code and checking step4-6 Troubleshooting procedure4-4 Troubleshooting the power unit 4-4 Troubleshooting the power unit (trouble code not detected)4-9 Troubleshooting the power unit using the diagnostic flash indicator 4-8 Troubleshooting the power unit using the YDIS 4-4 Troubleshooting the PTT unit 4-12, 4-13