2009 Yamaha F40 Outboard Service Manual, Page 363Get this manual
AAbbreviation 0-5 Adjusting the float height.6-33 Adjusting the forward gear shim thickness (T1) .8-34 Adjusting the pulser coil air gap 7-2 Adjusting the reverse gear shim thickness (T2) .8-37 Adjusting the shift cable 10-14 Adjusting the throttle link rod.6-22 Adjusting the throttle link rod and throttle cable 10-14 Adjusting the trim sensor cam (remote control model with PTT)9-39 Adjusting the valve clearance .7-4 After test run .10-8 Assemble the fuel filter assembly .6-10 Assembling the cylinder block.7-59 Assembling the cylinder head .7-42 Assembling the drive shaft8-17 Assembling the electrical components (multifunction) .9-13 Assembling the forward gear 8-17 Assembling the friction plate .9-3 Assembling the fuel pump assembly 6-14 Assembling the gear pump housing9-54 Assembling the lower case .8-15 Assembling the oil pan and exhaust manifold 9-31 Assembling the oil seal housing8-17 Assembling the propeller shaft assembly .8-8 Assembling the propeller shaft housing assembly.8-9 Assembling the PTT cylinder 9-58 Assembling the PTT motor .9-48 Assembling the shift rod9-15 Assembling the starter motor 5-37 Assembling the tiller handle 9-9 Assembling the upper case.9-26 Assembling the vapor separator .6-33