2009 Yamaha F40 Outboard Service Manual, Page 327Get this manual
Bracket unit
Removing the hydro tilt assembly
When removing the hydro tilt assembly with the power unit installed, make sure to suspend the outboard motor1Tilt the swivel bracket to the fully up position, and then support it with the tilt stop lever a
Checking the hydro tilt anode
1Check the anodeClean if there is grease, oil, or scalesNOTICE: Do not grease, oil, or paint the anode
Installing the hydro tilt assembly
1Install the anode a, the bushings b, and d2Install the hydro tilt assembly e, the upper mount shaft f, and the E-clips g3Install the collars h, i, and the lower mount shaft j, and then tighten the hydro tilt bolts k