2007-2009 Yamaha F15/F20 Outboard Service Manual, Page 240Get this manual
Electrical component and wiring harness routing Position the holder between the plastic tiesFasten the wiring harness at the white tape with plastic tieFasten the wiring harness, engine stop lanyard switch lead, and stator coil assembly lead with the holderInstall the terminals of the engine stop lanyard switch lead and wiring harness ground lead using the bolt, and then apply Yamaha grease to the terminals and boltFasten the lighting coil leads, wiring harness, and ground lead with the holderInstall the terminal of the oil pressure switch lead so that the lead is routed as shownApply Yamaha grease to the terminal and bolt, and then install the capInsert the rubber plugs into the lighting coil connectorsFasten the ignition coil lead with the holderFasten the wiring harness with plastic tiesInstall the plastic tie as shown and cut off the excess end of the tie to mm (0.12 in) or lessInstall the plastic ties as shownInstall the terminal of the ground lead using the bolt, making sure that the crimped section of the terminal that secures the ground lead is facing outward as shownThe connectors can be fastened in any position in the holder