2007-2009 Yamaha F15/F20 Outboard Service Manual, Page 186Get this manual
Tiller handle (tiller handle model) C D
S6AG7470
S6AG7A00
NOTE: Tighten the screws 9, and then tighten the screw 0Engine stop lanyard switch nut 5: Nm (0.2 kgfm, 1.5 ftlb) Bracket screw 8: Nm (0.4 kgfm, 3.0 ftlb) Power tilt switch screw and 0: Nm (0.4 kgfm, 3.0 ftlb)
NOTE: When routing the engine stop lanyard switch lead and power tilt switch lead (power tilt model), make sure that it is not pinched by the plate and that there is no slack in the lead in the area shown Make sure that the ends of the outer throttle cables are fitted securely into the grommet as shown6Install the tiller handle bracket to the steering bracket, and then install the tiller handle bracket cover and tighten the bolts to the specified torqueTiller handle bracket cover bolt: Nm (0.8 kgfm, 5.9 ftlb)