2005 Yamaha F90TR 90HP Outboards Factory Service Manual, Page 237Get this manual
IIdentification1-5 Ignition and ignition control system.8-7 Installing the clamp brackets.7-21 Installing the cylinder head .5-33 Installing the drive shaft 6-20 Installing the exhaust cover 5-38 Installing the fuel hose clamp4-15 Installing the lower unit .6-22 Installing the power trim and tilt unit7-44 Installing the power unit 5-51 Installing the pressure control valve5-38 Installing the propeller shaft housing 6-20 Installing the sprockets and timing belt .5-18 Installing the steering arm.7-18 Installing the throttle position sensor.4-9 Installing the upper case .7-15 Installing the valves.5-33 Installing the water pump and shift rod .6-21 Intake manifold4-7 Introduction .9-2
RReducing the fuel pressure4-13 Refacing the valve seat 5-30 Removing the clamp brackets 7-21 Removing the cylinder head 5-26 Removing the drive shaft 6-17 Removing the exhaust cover 5-38 Removing the fuel hose clamp 4-15 Removing the lower unit 6-8 Removing the power trim and tilt unit 7-24 Removing the power unit 5-16 Removing the propeller shaft housing assembly 6-11 Removing the steering arm 7-18 Removing the timing belt and sprockets5-17 Removing the upper case7-12 Removing the water pump and shift rod6-9 Replacing the oil filter 3-5 Replacing the timing belt 5-13 Replacing the valve guides5-28