2005 Yamaha F90TR 90HP Outboards Factory Service Manual, Page 38Get this manual
Control system 5Align the alignment mark on the bushing and alignment mark on the bracket S69J3370
WARNING
The throttle cable joint must be screwed in minimum of 8.0 mm (0.31 in) c12Connect the throttle cable joint, install the clip, and then tighten the locknut13Check the throttle cable for smooth operation and, if necessary, repeat steps 1214Install the intake silencer6Install the clip 4S6D81040
7Adjust the position of the shift cable joint until its hole is aligned with the set pin
Checking the gear shift operation
1Check that the gear shift operates smoothly when shifting it from neutral to forward or reverseAdjust the shift cable length if necessary2Set the gear shift to the neutral position3Loosen the locknut 1, remove the clip 2, and then disconnect the shift cable joint 34Remove the clip 4