2001-2002 Yamaha 50HP F50Z/T50Z Ouboard 4-stroke engines service manual, Page 312Get this manual
Clamp brackets 4Inject grease into both grease nipples until grease comes out from the bushings 4Fully tilt the outboard downMeasure the trim sensor resistanceRepeat steps 1-5 if out of specification
Adjusting the trim sensor
1Fully tilt the outboard up, and then support it with the tilt stop lever CDTrim sensor setting resistance: Pink (P)Black (B) 11 at 20C (68 OF) 6Fully tilt the outboard up, and then support it with the tilt stop lever
A WARNING
After tilting up the outboard, be sure to support it with the tilt stop leverOtherwise, the outboard could suddenly lower if the power trim and tilt unit should lose fluid pressure7Tighten the cam screws fied torque