1991 Yamaha Outboard Factory Service Manual 9.9 and 15 HP, Page 68Get this manual
2Bolt the gasket and reed valve assembly to the crankcaseNOTE: _ Make sure the reed valve assembly and crankcase are free of dust and dirtApply Yamaha Bond No.4 to the specified area of the gasket Throttle control link Screw the lever to the cylinder through the bracket
Shift control Install the link bracket onto the crankcase
1Gasket
2Apply Yamaha Bond No.4
Carburetor and silencer cover For the procedure for carburetor and silencer cover.installation, refer to page 3-17NOTE: 1The gasket between the carburetor and reed valve assembly has hole which should be aligned with the hole through which the crankcase pulses operating the fuel pump are obtained2For easy operation, place the engine on the lower unit first and then install the silencer coverDrainless hose Fit two clips around the drainless hoseConnect one end of the hose to the delivery side of the check valve and the other end to the joint on the intake side, and lock with the clips