Suzuki outboard motors 1988 2003 repair manual., Page 381Get this manual
12-8 SUPPLEMENT IGNITION COIL SPECIFICATIONS
Ignition coil testing may be accomplished using either an analog or digital voltohmmeterYou will obtain the best results using DVOM which includes capacitor checkerResistance is measured in ohms (identified with the Greek letter Omega, which appears as small hump-backedcaterpillar)All resistance specs were derived at temp of 70F (20C)
DT100IDT90
Condenser charge coil resPulser coil resistance Gear counter coil resistance Ignition coil resI
Ohm Ohm OhmData
180270 160230 160230
Ohm 0.150.25 Ohm 2.63.8 (plug cap res) Batt charge coil resOhm 0.40.6 Batt charge coil output Watts 200 (12V) Fuse rating Amps 25 Fuel starter solenoid res Ohms 5075 Starter relay res Ohms 3.04.0 PTT relay resistance Ohms 3.0 4.5 NOTE: This data was based on 90 "L" ModelsHowever it is applicable through the end of the model run Primary Secondary
Condenser chargecoil res Pulser coilcounter coil res Ignition coil res#I
Ohm Ohm Ohm Primary Secondary