Suzuki outboard motors 1988 2003 repair manual., Page 351Get this manual
REMOTE CONTROL 10-9 9Carefully remove the tiller handle from the bracketTo install: 10Lubricate the throttle reel where the cable makes contact and the tiller handle where it goes through the engine case11Carefully guide the throttle cable and wiring harness through the hole in the case and install tiller handle12Install the tiller handle inner bushing and mount13Install the stopper on the tiller handle14Install the rubber grommets on the stopper15Remove the tiller handle through bolts and tighten securely16Connect the engine stop switch wiring harness17Install the throttle cable and adjust the throttle cable tensionTighten the locknut securely18Operate the throttle grip and check for proper operation at full throttle and idle19Install the engine cover Dual Cables
ISee Figure 17
Remove the engine cover Place the throttle grip in the idle position on the tiller arm Loosen the locknut, slacken the adjustment on the throttle cables and