Suzuki outboard motors 1988 2003 repair manual., Page 349Get this manual
REMOTE CONTROL 10-7 Fig13 To release the trimltilt harness from the remote control box, pinch this connector with needle nose pliers
Fig14 The warning buzzer must be removed from the remote control box prior to testing
8Remove the control lever grip from the control lever taking care to not pull on the tiltltrim wiring harnessas you thread it though the holes in the control lever9Remove the tiltltrim switch from the lever gripTo install: 10Install the tiltltrim switch in the lever grip11Thread the tiltltrim wiring harness through the control lever and install the control lever gripSecure the grip with the screw12Install the neutral release lever and lever spring, securing them with the setting plate and screw13Connect the tiltltrim wiring harness14Install the remote control lever securing them with the bolt and washer to the remote control box15Install the control box from the side of the boat and open the side covers to allow access to the internal componentsTESTING