Suzuki outboard motors 1988 2003 repair manual., Page 347Get this manual
REMOTE CONTROL 10-5 234box5 Disconnect the neutral safety switch wiring harnessRemove any wire straps that connect the switch to the control boxRemove any retaining nutslscrews that secure the switch to the control
Remove the switch from the control boxTo install: 6Install the switch on the control box7As required, install the switch retaining nutlscrew and tighten securely8Install any wire straps that connect the switch to the control box or bracket9Connect the neutral safety switch wiring harness10Test the switch for proper operation11Install the control box side covers and mount the control box in the boatTESTING
1Disconnect the engine stop switch wiring harness2Connect multimeter between the switch harness leads3With the switch engaged (button pushed), continuity should existWith the switch released (button not pushed), continuity should not exist4If the switch does not function as specified there is short in either the switch or harness and the switch should be replaced5If the switch functions properly, there may be problem in the powerhead wiring harnessI
Fig8 Connect multimeter between the switch harness leadsWith the switch released (as shown), continuity should not exist
REMOVALINSTALLATION