Suzuki outboard motors 1988 2003 repair manual., Page 326Get this manual
8-58 LOWER UNIT
Fig62 Place the driveshaft bearing assembly into the jet drive housingRotate the bearing assembly until all bolt holes align Shimming Jet Impeller
Fig63 The clearance between the outer edge of the jet drive impeller and the water intake housing cone wall should be maintained at approximately Vs2 in(0.8mm)
Fig64 Spacers are used depending on the model being servicedWhen new, all spacers are located at the tapered (or nut) end of the impeller
ISee Figures 63 and 64